Re: STAT Press Release

From: Marshall Burns (
Date: Thu Jan 04 2001 - 04:03:08 EET


    You say you have two registered trade secrets. What is a registered trade secret?

Best regards,
Marshall Burns
President, Ennex Corporation
Los Angeles, USA, (310) 397-1314

  ----- Original Message -----
  From: Earl Dunlap
  Sent: Wednesday, January 3, 2001 11:40
  Subject: FW: STAT Press Release


  I am not offended at all and I have been fielding alot of questions on STAT fro two weeks now. We will be published in some trade magazines over the next few months and maybe we will let a little more information out but for the two main parts of what makes STAT work will stay a registered "Trade Secret". To answer your question about patents? We do have a patent in process and 2 registered trade secrets. We started selling this is November 1999 on a limited bases so we could develop and refine the process.

  We are combining traditional rapid tooling and composite technology. We use a 2 layer coating process on parts of the tool to handle heat and pressures. We have adapted molding presses with special setups to handle the STAT molds so pressures and heat does not hurt the STAT tool. We have compared in our press release other technologies as to capabilities. Unfortunate this is all I can release at this time along with the other information in that press release. I hope this helps satisfy your questions.

  Again, I apologize to you if you thought I was unset at your questions. I will gladly answer your questions if I can. Again, I invite you to visit Catalyst if you can?


  Earl Dunlap
  Vice President

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:40 EET