I don't know if this will work for this application, but you can check out
"Where Innovation Takes Shape"
----- Original Message -----
From: "Ian Gibson" <firstname.lastname@example.org>
Sent: Tuesday, April 10, 2001 9:01 PM
Subject: Another question
> Dear rp-ml
> I have a contact who wants to coat plastic parts with a 'rubber-like'
> material. The requirements are similar to the elastomeric materials used
> for toothbrush handles and on pen barrels.
> As I understand it, this is normally achieved using removable insert
> injection moulding, which is costly and we don't want to go this route
> without knowing that it works first.
> Is there a way to prototype this effect by spray coating an elastomeric
> compound on to a plastic part?
> Dr. Ian Gibson
> Associate Professor
> Dept. Mechanical Engineering
> The University of Hong Kong
> tel: +852 28597901
> fax: +852 28585415
> email: email@example.com
> Don't look around to find the sound that's right beneath your feet.
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:05 EET