Here at FineLine Prototyping we specialize in making very small prototypes
using stereolithography with a narrow-focused laser beam. The equipment is
much the same as in standard SL, but we use a special laser and careful
handling. We routinely make things of the dimensions that you describe, and
our process is much more economical than microstereolithography.
If you would send me the geometry information then I would be happy to give
you a quote.
FineLine Prototyping, Inc.
6300 Limousine DR
Raleigh, NC 27613
----- Original Message -----
From: "Steinar Killi" <Steinar.Killi@aho.no>
Sent: Tuesday, May 15, 2001 6:31 AM
Subject: Very small prototypes
> Dear list!
> We are trying to find a method to make prototypes of a very small turbin,
> Diameter 9 mm, height 2 mm, the turbinblades are 0.5 mm thick.
> Is this possible? and if so, who could do it?
> Drawings of the turbin can be achieved by contacting me either by mail
> or by phone.
> Steinar Killi
> Ass. Professor
> Oslo School of Arxhitecture (Norway)
> ph: +47 22 99 71 46
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:17 EET