RE: higher temp options

From: Brent Stucker (
Date: Tue Apr 23 2002 - 16:30:28 EEST


I developed an inexpensive method for doing this with SLS. I process zircon
sand with a thermosetting binder and then infiltrate the part with a
high-temperature epoxy and cure in an oven. It's fast, cheap gives good
dimensional accuracy.

Brent Stucker
Univ. of RI

-----Original Message-----
From: []On
Behalf Of
Sent: Tuesday, April 23, 2002 7:58 AM
Subject: higher temp options

We have a request for options on producing RP models that will
sustain/perform at 500 degrees F.


Bill Groethe
Howmet Research Corp
231 894 7007

For more information about the rp-ml, see

For more information about the rp-ml, see

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:43 EET