SLS Duraform PA parts leaning

From: Mullen, John (
Date: Fri Nov 08 2002 - 17:54:06 EET


Looking for ideas and suggestions........a couple of weeks ago we were
experiencing a very visible lean/shift towards the left in models built on
our 2500+. The build material is Duraform PA.

The left IR sensor, a new roller and the part bed heater were replaced.
Everything seemed okay, the parts we've been building looked good, but this
morning we broke out a new build and see the "Leaning Tower of Pisa"
phenomenon again.

Has anyone else experienced this in the past? Any ideas/suggestions what
could be causing this?

Thanks in advance,

John Mullen

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:34 EET