RE: SLS Machines Locking Up

From: Scott Tilton (
Date: Wed Feb 26 2003 - 18:33:45 EET

Exporting the build packet, importing it on the local Sinterstation computer
and then disconnecting that computer from the outside network has been a
standard operating procedure for me for a year or so now.
As has been the practice of rebooting both of the Sinterstation's computers
before each build.
It is a little annoying routine to have to perform and can't say for certain
how much affect it has had on the reliability, but it *seems* to have helped
things run better.
I found that if the machine stalled, and I had not done every reasonable
thing that I could do to avoid it, I'd end up pissed off and second guessing
Scott Tilton
-----Original Message-----
From: David K. Leigh []
Sent: Wednesday, February 26, 2003 10:04 AM
To: Rapid Mailing List
Subject: SLS Machines Locking Up
If you have the newer software, it will behave the same as a newer machine
(in my experience). We've got several levels of software here, and have
found that as it has gotten more "user friendly" over time, the reliability
and consistency has not seen the same upgrade. We have problems with our HS
locking up. Most of our issues with locking up has to do with it being
connected to the network. We've taken to unplugging the blasted thing from
the network before we start a build. This seems to work great.
As far as the number of parts in a layer, we've built 90 individual .stls in
a single layer in a 2500, 2500plus, Vanguard, and Vanguard HS without a
David K. Leigh (254) 933-1000
Harvest Technologies, Inc. fax (254) 298-0125
Rapid Prototyping Services

This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:11 EET