From: Evan Kirby (EKirby@materialise.com)
Date: Fri Jul 11 2003 - 23:05:26 EEST
Have you tried analyzing the part in Magics?
From: Tom Hester [mailto:email@example.com]
Sent: Friday, July 11, 2003 2:19 PM
Subject: CONVERTING MAYA 4.5 MODELS TO .stl FILES
We have had success with RP models modeled in Maya 4.5 until recently when
we noticed holes in certain surfaces while reviewing the geometry in the
Catalyst software. However, when we went back into Maya to locate the holes
so that we could repair them, there didn't appear to be anything wrong. All
normals were properly oriented, all CV's were attached and uncrossed, no
objects had open ends or obvious holes. The catalyst test-build shows no
yellow streaks yet rotating the model definitely revealed streaks and
notches characteristic of the presence of holes in the geometry. When the
file was sent over to the Stratasys machine it wouldn't print and showed the
same holes that Catalyst showed. How can we review the original geometry in
a way that shows us the holes? Right now nothing we do shows us the problem
in a way we can respond to or fix. The model is a small character figure
posed on a flat cylindrical base with inset text on the top of the base and
around the curved side.
When we use PolyTrans to make the .stl we get the following error message:
"Pre-processing geometry (if export appears to hang, Maya has experienced a
NURBS tessellation problem)". The model is eight polygonal objects
positioned relative to each other with overlaps previously sufficient to
generate a solid object print-out. This time, for some reason, we are having
this baffling problem. The inset letters are made with Booleans.
Any clues are much appreciated.
Thanks! Great forum!
Do you Yahoo!?
bc/> Yahoo! DSL - Now only $29.95 per month!
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:17:48 EET