Re: Custom made computer case

From: Jaquiss, Robert (
Date: Wed Dec 17 2003 - 14:59:57 EET

Hello Readers:
     I have just read Marshall Burns's posting, and some of the
responses. One aspect in designing a computer case is that it has to
stop Radio Frequency (RF) signals from leaving the computer case. It is
my understanding that the Federal Communications Commission (FCC) has
regulations on this. I am not an expert in this field, so I would
suggest checking with the FCC. Hope this helps.
    Merry Christmas,
    Robert Jaquiss

----- Original Message -----
From: Marshall <> Burns
To: 'Rapid Prototyping e-Mail List' <>
Sent: Tuesday, December 16, 2003 3:17 PM
Subject: Custom made computer case

Hello RP-ers,
    An associate is interested in manufacturing computers cases in
one-off quantities for special customers. I'd like to ask if anyone has
any thoughts or suggestions to share on the subject.
        -- What technique would you use for such a project? Sheet metal?
Vacuum forming on an RP master? Something else?
        -- What would you expect the cost per case to be, assuming a
normal desktop size?
        -- How crazy is this idea?
    Thanks for your assistance.
Best regards,
Marshall Burns
Ennex Corporation
Check out the NEW design of our Web site:
<> <>

This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:18:27 EET