RE: [rp-ml] FW: Geometric Accuracy of RP parts

From: Marshall Burns <>
Date: Tue Dec 28 2004 - 04:57:29 EET

    This is a very important idea you're looking into. I don't have
specific recommendations of scanners for you, but just thought I'd chime
in about the concept. Even in a terrestrial application, it's this kind
of thing that will provide the feedback to ensure that a fabber is on
track, and let it make mid-course corrections. It's obviously that much
more critical in a remote application, like space.
    I'd be interested to learn more about your project as it progresses.
Best regards,
Marshall Burns
www. <>

-----Original Message-----
From: [] On
Behalf Of Good, Jim
Sent: Monday, December 20, 2004 13:45
Subject: [rp-ml] FW: Geometric Accuracy of RP parts

I thought I would throw this out. I am looking into inspection
equipment that will verify the geometric accuracy of my RP part, after
fabrication, and actually during fabrication. I've looked at laser
scanning and got some good input already. I'd like everyone's opinion
on what system they are using and what they believe to be the best
system to verify geometric accuracy. The ultimate goal is to build a
fabricator that contains an integral inspection station. This system
would be used in space for repair and fabrication of new parts. Any




Jim Good


Muniz Engineering Inc.

In Situ Fabrication and Repair (ISFR)



Received on Tue Dec 28 03:59:11 2004

This archive was generated by hypermail 2.1.8 : Tue Jan 12 2010 - 19:37:12 EET