Re: [rp-ml] usual velocities

From: Brock Hinzmann (
Date: Tue May 24 2005 - 23:43:26 EEST

Perhaps I don't understand if theee is a specific place
that covers the exact topic, but if you Google injection
molding velocities, you will get a long list of references
that discuss ceramic and powder metal as well as plastic
injection molding velocities, including standard
references and references in the literature of companies
that sell IM equipment.

On Tue, 24 May 2005 13:01:49 -0400
  Paul Suomala <> wrote:
>Javier Delgado wrote:
>>Dear RP Friends,
>>I'm looking for information about plastic injection
>>mould. We are trying to
>>obtain sintered parts to integrate them in the plastic
>>injection mould. It
>>would be great if someone could tell me something about
>>the usual velocities
>>of plastic injection or any place where is possible to
>>find this
>>thank very much in advantage
>>Javier Delgado
>>Unidad Ingeniería de Producto (Area de Prototipado)
>>Parque Tecnológico, Avda. Leonardo Da Vinci, 38
>>Tel. +34 96 136 63 76 - Fax +34 96 131 81 68
> From your web site link I was able to find the
>AIMME regularly collaborates with other technological
>centres, bodies and institutes.
>The most important being:
> * AIMPLAS, Plastics Technology Institute, (Valencia).
>If there is not any pertinent information available from
>that source, I
>would recommend seeking advice from a sales
>representative of a major supplier of thermoplastics.
>Good luck,
>Paul S

This archive was generated by hypermail 2.1.7 : Mon Jan 02 2006 - 08:09:13 EET