Date: Mon Jan 29 2007 - 22:58:29 EET
One of our clients had some parts produced on an Invision System. These
parts were about 8 inches long and had a bend in them that looked like the 2 x 4
's at Home Depot. In other words, they were bent considerably when you
Have any of the members of this list seen the same evidence of curling when
making parts longer than 6 inches?
I would expect that the Envision parts might have the same problem, but we
do not have any direct evidence of that.
This archive was generated by hypermail 2.1.7 : Tue Jan 01 2008 - 18:13:00 EET