RE: [rp-ml]

From: Bob Olsen <>
Date: Wed Jun 10 2009 - 16:48:58 EEST

Amit, if I understand your question correctly, Somos Watershed XC11122
SLA resin should work. It is an FDA Class VI material when processed
properly, and is clear. There is more information here. <>

Many service bureaus run this material, and might be able to help if the
material meets your needs.

Best regards, Bob Olsen

Protogenic - a Division of Spectrum Plastics Group

Bob Olsen sales executive
7401 Church Ranch Blvd., Ste 206
Westminster, CO 80021

* Direct: 303-453-3990
* Fax: 303-453-8016
* web:
This message is confidential and intended for the individual or entity
named above. If you are not the intended recipient, please do not read,
copy, use or disclose this communication to others; also please notify
the sender by replying to this message, and then delete it from your
system. Please verify that you will delete the e-mail in your reply.
Thank you.


From: [] On
Behalf Of Amit Singh
Sent: Tuesday, June 09, 2009 11:50 PM
Subject: [rp-ml]

We need to get a job done for some Biomedical purpose and the nature of
of the prototyped part requires some transparency or may be a different
colour. From where can I get the part built up. Any help on issue will
be appreciated.

Amit Kumar Singh
Lecturer, Mechanical Engg Group
Nucleus Member, Research & Consultancy Division
BITS Pilani
Received on Wed Jun 10 16:47:52 2009

This archive was generated by hypermail 2.1.8 : Thu Jan 07 2010 - 08:26:36 EET