DAN DAVIS, RAPID PROTOTYPE wrote:
> Brockware. E-mail Brock Rooney at brock@mich.com or look on the
> Materialise web site http://wwww.materialise.com . They resell
> Brockware along with their Magics packages.
>
> Along the same lines, does anyone out there have any experience with the
> Brockware CATIA-to-STL translator -- is it as good as they say (even
> w/latest CATIA revs) and how much does it cost?
>
> Regards,
> > Dan Davis
> > Division Head, RP&M
> > Perusahaan Otomobil Nasional Berhad (PROTON)
> Hicom Industrial Estate
> Batu 3 PO Box 7100
> Shah Alam, Selangor D. E.
> 40918 MALAYSIA
> > +60 3 515-3906 direct line
> > +60 3 515-2380 direct fax
> > +60 12 277-5770 hand phone
> >
> > ----------
> > From: Vdub1963[SMTP:Vdub1963@aol.com]
> > Sent: Sunday, 15 March, 1998 06:11
> > To: rp-ml@bart.lpt.fi
> > Subject: IGES to STL
> >
> > What is a good translator to use?
>
> ------------------------------------------------------------------------
>
> Part 1.2 Type: application/ms-tnef
> Encoding: base64
Hi DAN:
I like to comment that I have used the CATIA to Stl utility (with
CATIA 4.1.7) , I really works well,
including BIG models, like cylinder heads or engine blocks.
I think that latest versions of the STL utility is about $ 8,000.
that's really something .....
-- _________________________________________________________________ Victor Cuauhtemoc Moreno Design Engineer NEMAK Corp. Tels: (52 8) 318 52 00 ext. 5359,e-mail : vmoreno@nemak.com.mx ________________________________________________________________
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:06 EEST