QuickCast foundry tips?

From: DANIEL CHARLES DAVIS (DANIEL@proton.com.my)
Date: Wed Sep 02 1998 - 09:54:31 EEST

Next message: Ian Gibson: "Internet conference"
Previous message: Monica & Glenn Whiteside: "ATTN: Igor RE: Possible portable and reconfigurable RP models?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello all,

Does anyone know the procedures used by foundries in regards to preping
a QuickCast part for foundry use? I'm interested in special procedures
in burnout (temps, equipment, etc.), special gating, etc. Thanks.

--- Regards, Dan Davis PROTON Rapid Prototyping Center Hicom Industrial Estate Batu Tiga, PO Box 7100 Shah Alam, 40918 Selangor MALAYSIA +60 3 515-2380 phone/fax

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Ian Gibson: "Internet conference"
Previous message: Monica & Glenn Whiteside: "ATTN: Igor RE: Possible portable and reconfigurable RP models?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:36 EEST