This past weekend, I had some parts running on the SLA machine, and apparently
there was a power outage during the build. Monday morning, then machine was
off with the zephyr bar sitting idle in the middle. Subsequently, the laser
took a looooonnnngggg time getting warmed up, and I had to redefine where the
laser scanned the sensors. The whole process was 3 hours of lost time.
Does anybody know of a good backup power system, or something that will
gradually turn the machine off in case of another power failure?
Thanks,
-- Keith D. Wheadon Rapid Prototyping Manager Solid Design & Analysis Ph (801)328-8220 www.sdaa.com email: keith.wheadon@sdaa.comFor more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:14 EEST