Dear List,
fcubic has recently made some parts for a customer with very small
holes. The photo on the link below shows a SEM picture of a sintered,
untreated stainless 316L part. At these small dimensions it is
actually difficult to see the holes. The part is approximately 12*6*2
mm.
http://www.fcubic.com/page6/files/page6-1000-full.html
Is there anyone with laser sintering experience who has worked with
fine features, holes etc and can compare. Any articles or publications?
Best Regards,
Urban Harrysson
---------------------------------------
Urban Harrysson
fcubic ab
www.fcubic.com
urban.harrysson@fcubic.com
Phone +46 31 706 6162
Handy +46-70-6 25 25 17
Received on Fri Oct 03 17:57:45 2008
This archive was generated by hypermail 2.1.8 : Tue Jan 06 2009 - 15:48:27 EET